Design and ُSimulation of a New High CMRR, High Bandwidth and Low Power Current Mode Instrumentation Amplifier Based on FDCCII
Subject Areas : electrical and computer engineeringS. Ahmadi 1 , S. J. Azhari 2 *
1 - University of Science and Technology
2 - University of Science and Technology
Abstract :
In this paper a novel topology of CMIA based on FDCCII is proposed. Due to benefiting from current mode signal processing, unlike the most of the previously reported IAs, the proposed FDCCII based structure doesn't need well-matched resistors or active blocks to obtain high CMRR and inherently can improve CMRR, bandwidth, power consumption and it has better frequency performances. On the other side, unlike other current mode types of this group, using fully differential structure decreases the mismatch effect in electronic blocks. Both of these advantages significantly reduced the structure size and power consumption while improving bandwidth and CMRR and makes it an excellent and an unbeatable choice for integration. In the proposed circuit, CMRR as the most important property of IA has been greatly improved by using a current subtracting stage. The CMIA has been designed using 0.18 um CMOS Technology under ±1 V supply voltages and the performance of the CMIA has been verified using HSPICE software in transistor level. The CMIA has achieved voltage CMRR of 227.4 dB, voltage CMRR bandwidth of 8.98 KHz, differential voltage gain bandwidth of 9.08 MHz and output offset voltage of 2.23 uV and the IA’s power dissipation is only 348 uW
[1] A. J. Annema, B. Nauta, R. V. Langevelde, and H. Tuinhout, "Analogue circuits in ultra-deep-submicron CMOS," IEEE J. Solid-State Circuits, vol. 40, no. 1, pp. 132-143, Jan. 2005.
[2] S. J. Azhari, Low Voltage Low Power Integrated Circuits, Analog and Digital, Lecture Note Iran University of Science and Technology, 2015-2016.
[3] C. Toumazou, F. J. Lidgey, and D. G. Haigh, Analogue IC Design: The Current-Mode Approach, London, U. K., IEE Press, 1990.
[4] S. J. Azhari, Current-Mode Integrated Circuits, Design and Application, Lecture Note Iran University of Science and Technology, 2015.
[5] G. Ferri and N. C. Guirrini, Low-Voltage, Low-Power CMOS Current Conveyors, ch.4, Kluwer, 2003.
[6] S. Archana, B. K. Madhavi, and I. V. Murali Krishna, "Design of CMOS current mode and voltage mode winner take all circuit on 180 nm technology," in Proc. IEEE Int. Conf. on Electrical, Electronics, and Optimization Techniques, ICEEOT'16, pp. 1879-1882, Chennai, India, 3-5 Mar. 2016.
[7] H. Broomandnia and S. J. Azhari, "Design of a fully differential current buffer (FDCB) based on a new common mode feedforward (CMFF) based common mode separation technique," in Proc. IEEE 2nd Int. Conf. on. Knowledge-Based Engineering and Innovation, KBEI'15, pp. 373-379, Tehran, Iran, 5-6 Nov. 2015.
[8] E. L. Douglas, D. F. Lovely, and D. M. Luke, "A low-voltage current-mode instrumentation amplifier designed in a 0.18-micron CMOS technology," in Proc. Canadian Conf. on Electrical and Computer Engineering, vol. 3, pp. 1777-1780, Niagara Falls, ON, Canada, 2-5 May 2004.
[9] S. J. Azhari and H. Fazlalipoor, "CMRR in voltage-op-amp-based current-mode instrumentation amplifiers (CMIA)," IEEE Trans. on Instrumentation and Measurement, vol. 58, no. 3, pp. 563-569, Mar. 2009.
[10] A. Voulkidou, S. Siskos, and T. Laopoulos, "A low noise low offset current mode instrumentation amplifier," in Proc. 19th Int. Conf. Mixed Design of Integrated Circuits and Systems, pp. 203-207, 24-26 Warsaw, Poland, May 2012.
[11] B. Babaei and S. Mirzakuchaki, "High CMRR, low power and wideband current-mode instrumentation amplifier," in Proc. IEEE Int. Norchip Conf., pp. 3-4, Linkoping, Sweden, 20-21 Nov. 2006.
[12] S. J. Azhari and H. Fazlalipoor, "A novel current mode instrumentation amplifier (CMIA) topology," IEEE Trans. on Instrumentation and Measurement, vol. 49, no. 6, pp. 1272-1277, Dec. 2000.
[13] A. A. Silverio, R. S. J. Reyes, and W. Y. Chung, "A low power high CMRR CMOS instrumentation amplifier based on differential voltage-current conveyor for beta-dispersion range bio-impedance applications," Recent Researches in Circuits, Systems, Multimedia and Automatic Control, pp. 31-36, Rovaniemi, Finland, 18-20 Apr. 2012.
[14] A. Panchal, P. K. Jain, and D. S. Ajnar, "Instrumentation amplifier using differential voltage second generation current conveyor (DVCCII) in standard 0.18 μm CMOS technology," International J. of Engineering Science and Technology, vol. 3, no. 8, pp. 6525-6531, Aug. 2011.
[15] L. Safari and S. Minaei, "A novel resistor-free electronically adjustable current-mode instrumentation amplifier," Circuits, Systems, and Signal Processing, vol. 32, no. 3, pp. 1025-1038, Jun. 2013.
[16] L. Safari and S. Minaei, "New ECCII-based electronically controllable current-mode instrumentation amplifier with high frequency performance," in Proc. European Conf. on Circuit Theory and Design, ECCTD'17, 4 pp., Catania, Italy, 4-6 Sept. 2017.
[17] D. M. Das, et al., "Design considerations for high-cmrr low-power current mode instrumentation amplifier for biomedicai data acquisition systems," in Proc. 21st IEEE Int. Conf. on Electronics, Circuits and Systems, ICECS'14, pp. 251-254, Marseille, France, 7-10 Dec. 2014.
[18] Z. M'Harzi, M. Alami, and F. Temcamani, "A novel high bandwidth current mode instrumentation amplifier," in Proc. 27th Int. Conf. on Microelectronics, ICM'15, pp. 299-302, Casablanca, Morocco, 20-23 Dec. 2015.
[19] M. A. Eldeeb, et al., "A 0.4-V miniature CMOS current mode instrumentation amplifier," IEEE Trans. on Circuits and Systems II: Express Briefs, vol. 65, no. 3, pp. 261-265, Mar. 2018.
[20] M. Han, et al., "Bulk switching instrumentation amplifier for a high-impedance source in neural signal recording," IEEE Trans. on Circuits and Systems II: Express Briefs, vol. 62, no. 2, pp. 194-198, Feb. 2015.
[21] S. Ahmadi and S. J. Azhari, "A novel fully differential second generation current conveyor and its application as a very high CMRR instrumentation amplifier," Emerging Science J., vol. 2, no. 2, pp. 85-92, Apr. 2018.
[22] I. Gkotsis, G. Souliotis, and I. Haritantis, "Instrumentation amplifier based analogue interface," in Proc. IEEE Int. Conf. on Electronics, Circuits and Systems. Surfing the Waves of Science and Technology, pp. 317-320, Lisboa, Portugal, 7-10 Sept. 1998.
[23] S. Suwansawang and T. Thongleam, "A 1-V bulk-driven CMOS fully differential second-generation current conveyor," in Proc. IEEE Int. Symp. on Intelligent Signal Processing and Communications Systems, ISPACS'13, pp. 662-665, Naha, Japan, 12-15 Nov. 2013.